Sony DVS-9000 User Manual page 413

To make detailed settings for a VTR
1
2
3
4
5
412
Setup Relating to DCU
In the <DCU Select> group of the DCU >Serial Port Assign menu, select
the target for the setting (DCU1 or DCU2).
Using any of the following methods, select the serial port connected to the
VTR for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Port No Serial port
a) The range of setting values depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
Press [Port Setting].
The DCU >Serial Port Assign >VTR Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, SCU number, and timecode source appear. In the lower
part of the status area, the VTR constants appear.
In the <TC Source> group, select the timecode source (reference signal for
determining the tape position) from the following.
LTC (Longitudinal Time Code): Use LTC. When interpolation data is
returned from a VTR, use that interpolation data.
LTC: VITC (Vertical Interval Time Code): Normally use LTC, but
when the tape is moving at speeds at which LTC cannot be read, use
VITC.
When interpolation data is returned from a VTR, use that interpolation
data.
VITC: Use VITC.
CTL (Control): CTL pulses or timer counter pulses are used. Use this
only for a tape on which no timecode is recorded.
The displayed tape position is based on the reference signal specified here.
Using any of the following methods, specify the VTR constants.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Setting values
a)
1 and upwards