Sony DVS-9000 User Manual page 108

1
Press [Defocus], turning it on.
2
Set the following parameters.
Knob
1
2
Applying stardust to the afterimage portion
The afterimage portion becomes stardust, and gradually disappears.
1
Press the [DUST] button, turning it on.
2
Set the following parameters.
Knob
1
2
3
4
a) The way in which the afterimage disappears is affected by both Decay and Trail Dust
parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the combine.
Notes
• The combine process function is not supported on the MVE-8000A.
• When you change the selection in the <Combine Process> group, the
afterimages which had been added up to then disappear.
• When you do not combine images, the Trail effect only is applied, regardless
of the selection in the <Combine Process> group.
Select one of the following in the <Combine Process> group.
Combine –> Trail: Add the Trail effect after the combine. As the trail
parameters, the data for the channel with the lowest number among the
channels being combined is enabled.
Parameter Adjustment
Defocus V Defocusing of the video
signal
Defocus K Defocusing of the key
signal
Parameter Adjustment
Trail Dust Amount of the afterimage
disappearing as stardust
Dust Soft Timing with which stardust
disappears
Dust Size Size of stardust
Dust Aspect Aspect ratio of stardust
Setting values
0.00 to 100.00
0.00 to 100.00
Setting values
0.00 to 100.00
a)
0.00 to 100.00
0.00 to 100.00
–100.00 to +100.00
DME Special Effect Operations
107