Sony DVS-9000 User Manual page 276

Notes
• When operating an MVS-8000 system and a DVS-9000 system in Dual
Simul mode, simultaneous operation may not be possible because of
differences between the systems in some functions.
• For an MVS-8000 system, SD systems and HD systems store different
numbers of frames in frame memory. When operating an SD system and
an HD system in Dual Simul mode, use the HD system (which stores
fewer frames) as the first system (the system whose switcher ID is 1).
Specifying the switcher controlled by the control panel
1
In the System >System Config menu, press the [Panel Assign] button.
The Panel Assign menu appears.
2
Select the switcher to be controlled by the selected control panel, as
follows.
• If there is only one switcher on the network, in the <1st Switcher>
group, set [SWR1] to On, and in the <2nd Switcher> group, set [SWR2]
to Off.
• If there are two switchers on the same network, in the <1st Switcher>
group, select the switcher to be operated.
When the system operation mode (see previous item) is set to [Dual
Simul], the switcher status set in <1st Switcher> appears on the control
panel.
3
To set the selected control panel as tally control master panel, press [Tally
Master], turning it on.
If there are multiple panels and processors, the control panel for which
[Tally Master] is set to On carries out tally control for the whole system.
Note
When there are multiple control panels, make sure that one of them has
[Tally Master] set to On. When you change the master panel, be sure to
copy and save the setup tally (TLY) and router (RTR) data in the File
menu, and make the same settings for other panels.
Specifying the DME connected to the switcher
1
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
Setup for the Whole System
275