Normal: Carry out a preset color mix with two transition operations.
Single: Carry out a preset color mix with a single transition operation.
Note
In bus fixed mode (see page 372), the setting is fixed to "Single."
3
In the <Non Drop Key> group, select the key setting for a transition
including a key.
To carry out the transition with the key state maintained, press [Key1] to
[Key4], turning them on. (See "Transition Types" in Chapter 1 (Volume
1).)
4
If each time a transition ends the transition type is to return to the previous
setting, press [One Time Enable].
Settings relating to fader lever operations
To select the way in which the fader lever position and the transition progress
are related, use the following procedure.
1
In the Switcher >Transition menu, press [Transition Curve].
The Transition Curve menu appears.
2
In the <Fader Curve> group, select the fader lever operation mode.
Normal: The transition progress is linear, according to the fader lever
position. (Factory default setting)
Adv Tally Mode: When the fader lever is moved from the end of its travel,
the tally is output slightly before the transition starts.
Settings Relating to Keys, Wipes, Frame Memory and
Color Correction (Key/Wipe/FM/CCR Menu)
For settings relating to keys, wipes, frame memory and Color Correction, use
the Switcher >Key/Wipe/FM/CCR menu.
To display the Key/Wipe/FM/CCR menu
In the Engineering Setup menu, select VF3 'Switcher' and HF5 'Key/Wipe/
FM/CCR.'
The status area shows the key memory settings, mask and border processing
order, key priority, cross-point hold, pattern limit transition, and wipe edge
settings for each of the M/E and PGM/PST banks.
Setup Relating to Switcher Processor
373