Sony DVS-9000 User Manual page 399

6
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
398
Setup Relating to DME
Knob Parameter
3 Action
4 Reg No
a) • Action list when the trigger type is other than "Level"
When Target is Ch1, Ch2, Ch3, or Ch4: Freeze, SS ? Recall
Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, KF Reverse
Run, No Action
When Target is Proc: No Action
• Action list when the trigger type is "Level"
When Target is Ch1, Ch2, Ch3, or Ch4: Aspect, No Action
When Target is Proc: Format (frame/field rate, number of lines)
Aspect, Level Enable, No Action
Note
"Level Enable" is a function that determines whether GPI inputs are enabled
("Enable") or disabled ("Disable") for the "Aspect" and "Format" actions that can be
used when the trigger type is Level. When Level Enable is used, if the input is
"Disable" then it is not possible to switch "Aspect" or "Format" by GPI input.
If a GPI to switch "Aspect" or "Format" occurs when powering the system off, the
action triggered by the GPI may start immediately before the power goes off and the
power may go off before the action is completed. This may corrupt the setup settings.
It is therefore recommended to use Level Enable to avoid such a situation.
b) When knob 3 selection is "Snapshot"
c) When knob 3 selection is "Effect"
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
In the DME >Device Interface menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
1 No
Adjustment
Action selection
Register number
Adjustment
Signal format/screen aspect ratio
selection
Setting values
a)
1 and upwards
b)
1 to 99
c)
1 to 399
Setting values
1 and upwards