the Setup menu. For details, see "Setting the mode in which all signals can
be selected for input to the color corrector" (page 377).
Selecting the color corrector output signal
By assigning the signal output from the color corrector to a cross-point button,
you can make that signal available on that button.
For details of the assignment process, see "Cross-Point Settings (Xpt Assign
Menu)" (page 321).
Accessing the CCR menu
For color correction operations, use the CCR menu.
To access the CCR menu, in the menu control block, press the top menu
selection button [CCR].
The following description uses CCR1 as an example. To apply color correction
to CCR2, replace VF1 'CCR1' by VF2 'CCR2,' and follow the same
procedure.
515
Preparations