Table of Contents
Advertisement
Help Guide
Multi Channel AV Receiver/Multi Channel AV Amplifier
STR-AN1000/TA-AN1000
Checking Auto Calibration results
To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:
If an error code appears
Check the error and perform Auto Calibration again.
Select [Retry].
1
Follow the instructions on the TV screen to perform Auto Calibration.
2
Auto Calibration is performed twice.
When the measurement is completed, select the item you want.
3
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
Save the measurement results.
4
Select [Save] in step 3.
If the [SpeakerRelocation / PhantomSurroundBack] function screen is displayed, select the desired setting by
5
referring to
"Calibrating speaker positioning (SpeakerRelocation /
If [In-Ceiling Speaker Mode] is set to [Front & Center] or [Front], this screen will not be displayed, so proceed to step 6.
Select the desired calibration type by referring to
6
When the calibration matching function screen is displayed, select [Yes] or [No].
7
Yes: By expanding the sweet spot of the listening position and adjusting the sound wave on the left and right of each
speaker, you can enjoy more natural sound.
No: The measurement result of the Auto Calibration is applied as it is.
Perform the 360 Spatial Sound Mapping demo as needed.
8
If a warning message appears
Check the warning message and select [OK]. For details on the warning messages, see
Calibration
measurements."
Hint
The measurement results may vary depending on the position of the subwoofer. However, continuing to use the unit with that value
does not cause problems.
PhantomSurroundBack)."
"Selecting the Auto Calibration type (Calibration
98
Type)."
"List of messages after Auto
Advertisement
Table of Contents
