Table of Contents
Advertisement
Help Guide
Multi Channel AV Receiver/Multi Channel AV Amplifier
STR-AN1000/TA-AN1000
No sound or only a very low level of sound is heard from specific speakers.
Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one
channel is output from the headphones, the device may not be connected to the unit correctly. Check that all of the cables
are fully inserted into the jacks on both the unit and the device.
If both channels are output from the headphones, the front speaker may not be connected to the unit correctly. Check the
connection of the front speaker that is not outputting any sound.
Make sure you have connected to both the L and R jacks of an analog device, as analog devices require both L and R jack
connections. Use an audio cable (not supplied).
Adjust the speaker level.
Check that the speaker settings are appropriate for the setup using [Manual Speaker Settings] – [Speaker Pattern] in the
[Speaker Settings] menu. Then check that sound is output from each speaker correctly using [Manual Speaker Settings] –
[Test Tone] in the [Speaker Settings] menu.
Check that the subwoofer is connected correctly and securely.
Make sure you have turned on your subwoofer.
Check the volume on the subwoofer.
Depending on the selected sound field, sound may not be available from the subwoofer.
When you play content in the DTS format or the sound field is set to [DTS:X Mode], sound may not be output from the
height speakers. In this case, set [Speaker Pattern] in [Manual Speaker Settings] under [Speaker Settings] to [5.1.2 (FH)].
5-037-030-11(1) Copyright 2022 Sony Corporation
301
Advertisement
Table of Contents
