Table of Contents
Advertisement
Help Guide
Multi Channel AV Receiver/Multi Channel AV Amplifier
STR-AN1000/TA-AN1000
Performing Auto Calibration (Auto Calibration Settings)
You can perform Auto Calibration from your listening position.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Auto Calibration Settings].
2
Select [Auto Calibration], and then select [Start].
3
Follow the instructions on the TV screen to check the connection of external devices, set the speaker
4
configuration, and perform automatic measurement using the measurement microphone and microphone stand.
Auto Calibration is performed twice.
When the measurement is complete, select the item you want.
5
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
Save the measurement results.
6
Select [Save] in step 5.
Note
If the measurement fails, follow the message, then select [Retry]. For details on the error code and warning message, see
messages after Auto Calibration
This setting is not available when headphones are connected.
Hint
The Auto Calibration measurement will be canceled if you perform the following during the measurement process:
Press
(power).
Press the input buttons on the remote control or turn INPUT SELECTOR on the unit.
Press HOME, AMP MENU, HDMI OUT or
Press SPEAKERS on the unit.
Change the volume level.
Connect headphones.
Press MUSIC on the remote control or the unit.
measurements."
(muting) on the remote control.
5-037-030-11(1) Copyright 2022 Sony Corporation
193
"List of
Advertisement
Table of Contents
