Setting Dnp3 Signal Parameters - ABB Relion 650 Series Engineering Manual

1MRK 511 245-UUS A
1. Select one or several signals.
•
•
•
2. Press the blue arrow button to insert the selected signals into the configuration.
3. Press the green double arrow button to insert all signals into the configuration, see
IEC08000361 V1 EN-US
Figure 76: CMT: Move buttons
4. Click the drop down list
5. Repeat to move signals for all signal types and save the selection.
IEC08000339 V1 EN-US
Figure 77:
9.3

Setting DNP3 signal parameters

Two parameters per signal can be set for all signal types:
• The index of the signal
• The class configuration
Procedure to set the index of the signal:
1. Click the two inner arrows to sort signals to another index sequence, or select
from the context menu to move one or a set of signals to another array, see
650 series
Engineering manual
Click in the list of signals to select one signal.
Shift or Ctrl and several signals to select a set of signals.
Press
Right-click in the list of signals, select
to select all signals.
IEC08000361.vsd
Signal Type: to select the other signal types for this channel.
Content changes in the DNP3 container are marked with a star at the end of the
name, see Figure 77. The star indicates that changes in the container have to be
saved before leaving CMT.
IEC08000339.vsd
CMT: Marker to indicate changes in the container
© Copyright 2011 ABB. All rights reserved
Select All from the context menu or press Ctrl+A
Section 9
DNP3 communication engineering
Figure 76.
GUID-F762121A-41E5-49F1-9359-205CF9E15304 v1
Set Index ...
Figure 78.
95