Iec 61850 Engineering Procedure; Iec 61850 Protocol References And Pre-Conditions; Sequence For Engineering Of Iec 61850 Protocol - ABB Relion 650 Series Engineering Manual

Section 7
IEC 61850 communication engineering
7.2

IEC 61850 engineering procedure

7.2.1

IEC 61850 protocol references and pre-conditions

To engineer the IEC 61850 protocol interface for the IED, the following additional manuals or
knowledge of their contents is required.
• Knowledge of the IEC 61850 engineering process as described in the IEC 61850 standard.
• The Technical Manual describes function blocks defined as logical nodes.
• The IEC 61850 Communication Protocol Manual.
• The IEC 61850 conformance documents for the IED to be engineered.
7.2.2

Sequence for engineering of IEC 61850 protocol

The IEC 61850 standard defines the complete part needed for information communication in a
substation. This can be split into the following parts:
• Description of the substation part including the used logical nodes
• Description of the IEDs with their logical nodes
• Description of the communication network
• Description of the engineering process
For more details please refer to the IEC 61850 standards. In the following description it is assumed
that PCM600 together with CCT600 is used as system configuration tool.
A short form of a typical sequence is shown in
SCD file.
1. Export SCL files from PCM600. In the scenario in
are possible to export.
2. Configure horizontal and vertical communication in the station configuration tool, for
example CCT600.
3. Import SCL files to PCM600 project. In the scenario in
80
The uploading of IEC 61850 communication configuration is not supported when
reading a configuration from an online IED.
© Copyright 2011 ABB. All rights reserved
Figure 62 when a complete station is exported as a
Figure 62 it is a SCD file. Other SCL file types
Figure 62 it is the updated SCD file.
1MRK 511 245-UUS A
SEMOD58549-4 v3
SEMOD58549-17 v4
650 series
Engineering manual