ABB Relion 650 Series Engineering Manual page 75

1MRK 511 245-UUS A
The total size of the presented white area (page) represents the visible part of the local HMI
display without header and foot-line.
The visible display for a single line diagram is organized in a raster of 13 x 8 (columns x rows). Each
symbol -presented by 24 x 24 pixels- included by the drag and drop method must be dropped in a
raster box. The icon
apparatus object can be placed in all four directions around the symbol. The description is part of
the apparatus object. It is possible to place the symbols not under assistance of
Handling text
The raster switches when text is selected in a raster of 45 x 15 (columns x rows). One raster box is
the placeholder for one character. A text element must be placed in the position of the raster. The
name and the unit of a measurement or text symbol can be changed either by double click the
symbol or via the object property window.
Select and toggle
HMI display.
Doing Link to draw lines
The line width has to fit to the line width used for the symbols. The standard size is 2. Choose the
line width in a selection box placed in the upper area above the page. A line that is not connected
to a symbol may be done in any line width in the range 1 - 5. But it needs to be simple connection
points to be drawn.
Procedure to draw lines when the apparatus symbols are placed, see
1. Place the apparatus or transformer symbols by drag and drop in a raster box.
2. Place the connections symbols by drag and drop in a raster box.
3. Click the
4. Center the mouse pointer on the center of a connection point; visible in two circles at the
endpoints of a line, to draw a line.
5. Click to start and move the mouse pointer to the destination connection point. Center once
again the mouse pointer and click to drop the line.
6. Draw all line elements that are necessary.
7. Click
650 series
Engineering manual
Snap to grid must be enabled to place a symbol. The description text for an
Show Texts using the IED Fonts to get a view how it will look like later on the real
Link icon to enable direct line drawing.
Select in the menu bar to finish the line drawing.
© Copyright 2011 ABB. All rights reserved
Section 6
Local HMI engineering
Snap to Grid .
Figure 55:
69