Section 5
Protection and control engineering
IEC09000613 V2 EN-US
Figure 37: ACT: HW signal channels
5.1.8
Validation
Validation checks the application configuration on errors about the rules and restrictions defined
for doing a MainApplication on three levels.
•
During creating the logic while doing a connection or placing a function block.
•
On demand by starting the validation.
•
When writing the application configuration into the IED.
Validation when creating the application configuration
Validation is made when creating the application configuration, for example:
•
A connection between two input signals or two output signals is not possible.
•
A connection between two different data types is not possible, for example a binary output to
an analog input.
52
© Copyright 2011 ABB. All rights reserved
IEC09000613-2-en.vsd
GUID-7407C36C-15EB-4987-AF29-5DCEFB95A613 v2
1MRK 511 245-UUS A
650 series
Engineering manual