Local Hmi Engineering; Led And Function Key Engineering; Local Hmi Engineering Process - ABB Relion 650 Series Engineering Manual

1MRK 511 245-UUS A
Section 6
6.1

LED and function key engineering

6.1.1

Local HMI engineering process

The engineering process of the LEDLHMI involves several steps.
engineering step, the main steps in the engineering process and the required sequences.
ACT / SMT
Select and configure
HMI function blocks
keys and LEDs
GDE / ACT
single line diagram
IEC09000622 V1 EN-US
Figure 41: LHMI: Engineering process flowchart
• Application Configuration tool with possible assistance of Signal Matrix tool
•
•
•
•
• Parameter Setting tool
650 series
Engineering manual

Local HMI engineering

Local HMI
SAVE
PST
Set function
SAVE
Create the
SAVE
END
IEC09000622_1_en.vsd
To use the function keys and LEDs on LHMI it is needed to insert the corresponding
special function blocks for these operation element groups.
The function blocks for the LEDs are organized as single function block per LED but
indexed to the group identification, for example GRP1_LED3 (indication LED 3 in virtual
LED group 1).
The function blocks for LHMI are visible by default for Parameter Setting tool.
Use Application Configuration tool to connect start and trip signals from application
functions to LED function blocks.
© Copyright 2011 ABB. All rights reserved
Local HMI engineering
GUID-18B1952A-7578-4AC5-8A62-88FE60067292 v3
GUID-35126910-CF1C-4411-ACA9-72E1DB9BC68F v3
Figure 41 presents the pre-
Section 6
57