GS700TS Series Smart Switch Software User Manual
To configure LACP for LAGs:
1. Click LAG Configuration > LACP. The LACP Parameters Page opens:
Figure 5-48
The LACP Parameters Page contains the following fields:
•
LACP System Priority – Specifies system priority value. The field range is 1-65535. The
highest priority is 1 and the lowest is 65535. The field default is 1.
•
Unit No. – Displays the stacking member for which the LAG parameters are defined.
•
Interface – Displays the interface number to which timeout and priority values are
assigned.
•
Interface Priority – Displays the LACP priority value for the interface. The field range is
1-65535. The highest priority is 1 and the lowest is 65535. The field default is 1.
•
LACP Timeout – Displays the administrative LACP timeout. The short timeout time is 3
seconds and the long time out time is 90 seconds.
5-62
Configuring The Device Using Your Browser
v1.0, November 2006