To assign STP settings to an interface:
1. Click Advanced > Spanning Tree and click an interface. The Modify Spanning Tree Page
opens:
Figure 5-61
The Modify Spanning Tree Page contains the following fields:
•
Interface – The interface for which the information is displayed. The possible field values
are:
–
All Ports of the Stack – Selects all ports on the stack.
–
All LAGs – Selects all LAGs on the stack.
–
All Ports of Unit No. – Selects all ports of the selected unit number.
–
Port No. – Indicates the port number to which the setting should be applied.
–
LAG No. – Indicates the LAG number to which the setting should be applied.
•
STP – Indicates if STP is enabled on the port. The possible field values are:
–
Enable – Enables STP on the port.
Configuring The Device Using Your Browser
GS700TS Series Smart Switch Software User Manual
v1.0, November 2006
5-83