Table of Contents
Advertisement
NM3
6.36A.13 Return the low alarm limit to its original default setting.
6.36A.14 Decrease the high pulse alarm limit below the actual pulse rate.
6.36A.15 The pulse high LED will illuminate and an intermittent audible
6.36A.16 Return the pulse high alarm limit to its original default setting.
6.36A.17 Press the DISPLAY key and verify that SaO
6.36A.18 Press the LO key, and increase the SaO
6.36A.19 The SaO
6.36A.20 Return the low SaO
6.36A.21 Press the HI key, and decrease the SaO
NOTE:
6.36A.22 An intermittent audible alarm will sound. The Alarm CRT will
6.36A.23 Return the high SaO
6.36A.24 Remove the Pocket Tester from the preamp, and reconnect the
6.36A.25 Disable the SaO
Rev. V
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
alarm will be heard. The Alarm CRT will display "OXI PULSE HI".
the actual reading.
LED will flash red, and a continuous audible alarm will
2
sound. The Alarm CRT will display "OXI SAT LOW" in the Warning
column.
low alarm limit to its original default setting.
2
actual reading.
The monitor will not display any visual alarms.
display "OXI SAT HIGH".
2
finger probe.
alarms.
2
6-49B
RETURN TO CD-ROM TABLE OF CONTENTS
PMC PROCEDURE (continued)
% low alarm limit above
2
high alarm limit below the
2
alarm limit to its original default setting.
% is displayed.
2
Advertisement
Table of Contents
Troubleshooting
