Table of Contents
Advertisement
ADJUSTMENT AND CALIBRATION PROCEDURES (continued)
5.7.14
Turn the System Power Switch to STANDBY and remove AC power
from the machine.
5.7.15
Reinstall the top shelf on the monitor housing and re-connect its
ground wire.
5.7.16
Close the monitor housing back cover and replace the retaining
screws. Re-connect any external cables that were previously removed
from the serial ports.
5.7.17
Perform the PMS Procedure given in Section 6.
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
5-26
NM3
Advertisement
Table of Contents
Troubleshooting
