PMC PROCEDURE (continued)
( ) 6.11
Repack MAN/AUTO Selector Valve
6.11.1
Remove the four screws securing the stick shift block to the selector valve
body and remove the block.
6.11.2
Remove the spring and valve channel from the valve body.
6.11.3
Remove all residual lubricant from the valve channel.
6.11.4
Remove all residual lubricant from the valve body.
6.11.5
Apply a minimal amount of "stop cock" lubricant to the tapered surface
of the valve channel, and ensure complete coverage of lubricant.
6.11.6
Insert the valve channel into the valve body.
6.11.7
Insert the spring into the stick shift block.
6.11.8
Align the index pins on the stick shift block to the holes in the valve
channel.
6.11.9
Secure the stick shift block to the selector valve body with the four screws
that were previously removed.
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
6-20
NM3
Rev. V