Installation; Installation Conditions; Mounting Position - Endress+Hauser Proline Cubemass C 100 PROFIBUS DP Operating Instructions Manual

Proline Cubemass C 100 PROFIBUS DP
Endress+Hauser
6

Installation

6.1

Installation conditions

6.1.1

Mounting position

Mounting location
To prevent measuring errors arising from accumulation of gas bubbles in the measuring
tube, avoid the following mounting locations in the pipe:
• Highest point of a pipeline.
• Directly upstream of a free pipe outlet in a down pipe.
Installation in down pipes
However, the following installation suggestion allows for installation in an open vertical
pipeline. Pipe restrictions or the use of an orifice with a smaller cross-section than the
nominal diameter prevent the sensor running empty while measurement is in progress.
 4 Installation in a down pipe (e.g. for batching applications)
1 Supply tank
2 Sensor
3 Orifice plate, pipe restriction
4 Valve
5 Batching tank
1
2
3
4
5
Installation
A0028772
A0028773
19