Technical data
Power supply failure
Electrical connection
Potential equalization
Terminals
Cable entries
Cable specification
Reference operating
conditions
Maximum measured error
112
• Totalizers stop at the last value measured.
• Depending on the device version, the configuration is retained in the device memoryor in
the pluggable data memory (HistoROM DAT).
• Error messages (incl. total operated hours) are stored.
→ 30
→ 32
Transmitter
Spring terminals for wire cross-sections0.5 to 2.5 mm
• Cable gland: M20 × 1.5 with cable Ø 6 to 12 mm (0.24 to 0.47 in)
• Thread for cable entry:
• M20
• G ½"
• NPT ½"
→ 27
16.6
Performance characteristics
• Error limits based on ISO 11631
• Water with +15 to +45 °C (+59 to +113 °F) at2 to 6 bar (29 to 87 psi)
• Specifications as per calibration protocol
• Accuracy based on accredited calibration rigs that are traced to ISO 17025.
To obtain measured errors, use the Applicator sizing tool → 106
o.r. = of reading; 1 g/cm³ = 1 kg/l; T = medium temperature
Base accuracy
Design fundamentals → 115
Mass flow and volume flow (liquids)
±0.10 % o.r.
Mass flow (gases)
±0.50 % o.r.
Density (liquids)
Under reference conditions
[g/cm³]
±0.0005
1)
Valid over the entire temperature and density range
2)
Valid range for special density calibration: 0 to 2 g/cm³, +5 to +80 °C (+41 to +176 °F)
3)
Order code for "Application package", option EE "Special density"
Proline Cubemass C 100 PROFIBUS DP
2
(20 to 14 AWG)
1)
Standard density calibration
[g/cm³]
±0.02
Wide-range
2) 3)
Density specification
[g/cm³]
±0.002
Endress+Hauser
Need help?
Do you have a question about the Proline Cubemass C 100 PROFIBUS DP and is the answer not in the manual?