Power Supply - Endress+Hauser Proline Cubemass C 100 PROFIBUS DP Operating Instructions Manual

Proline Cubemass C 100 PROFIBUS DP
Terminal assignment
Pin assignment, device plug
Supply voltage
Power consumption
Current consumption
Endress+Hauser
Input values
(from automation system to
measuring device)
Supported functions
Configuration of the device
address
16.5

Power supply

→  28
→  29
The power unit must be tested to ensure it meets safety requirements (e.g. PELV, SELV).
Transmitter
DC 20 to 30 V
Transmitter
Order code for "Output"
Option L: PROFIBUS DP
Transmitter
Order code for "Output"
Option L: PROFIBUS DP
Analog output 1 to 3 (fixed assignment)
• Pressure
• Temperature
• Reference density
Digital output 1 to 3 (fixed assignment)
• Digital output 1: switch positive zero return on/off
• Digital output 2: perform zero point adjustment
• Digital output 3: switch switch output on/off
Totalizer 1 to 3
• Totalize
• Reset and hold
• Preset and hold
• Stop
• Operating mode configuration:
• Net flow total
• Forward flow total
• Reverse flow total
• Identification & Maintenance
Simplest device identification on the part of the control system and
nameplate
• PROFIBUS upload/download
Reading and writing parameters is up to ten times faster with PROFIBUS
upload/download
• Condensed status
Simplest and self-explanatory diagnostic information by categorizing
diagnostic messages that occur
• DIP switches on the I/O electronics module
• Via operating tools (e.g. FieldCare)
Current consumption
Technical data
Maximum
Power consumption
3.5 W
Maximum Maximum
switch-on current
145 mA 18 A (< 0.125 ms)
111