Endress+Hauser Proline Cubemass C 100 PROFIBUS DP Operating Instructions Manual page 110

Technical data
Low flow cut off
Galvanic isolation
Protocol-specific data
110
Web browser
Plain text display With information on cause and remedial measures
Light emitting diodes (LED)
Status information
The switch points for low flow cut off are user-selectable.
The following connections are galvanically isolated from each other:
• Outputs
• Power supply
Protocol-specific data
Manufacturer ID
Ident number
Profile version
Device description files (GSD,
DTM, DD)
Output values
(from measuring device to
automation system)
Status indicated by various light emitting diodes
The following information is displayed depending on the device version:
• Supply voltage active
• Data transmission active
• Device alarm/error has occurred

Diagnostic information via light emitting diodes →  85
0x11
0x1561
3.02
Information and files under:
• www.endress.com
On the product page for the device: Documents/Software → Device drivers
• www.profibus.org
Analog input 1 to 8
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
• Carrier mass flow
• Density
• Reference density
• Concentration
• Temperature
• Carrier pipe temperature
• Electronic temperature
• Oscillation frequency
• Oscillation amplitude
• Frequency fluctuation
• Oscillation damping
• Tube damping fluctuation
• Signal asymmetry
• Exciter current
Digital input 1 to 2
• Partially filled pipe detection
• Low flow cut off
Totalizer 1 to 3
• Mass flow
• Volume flow
• Corrected volume flow
Proline Cubemass C 100 PROFIBUS DP
Endress+Hauser