Table of Contents
Advertisement
PAPER TRANSPORT, FUSING, AND PAPER EXIT SECTIONS
6.9.10 HOT ROLLER AND CLEANING ROLLER REPLACEMENT
AND CLEANING
[D]
[F]
[E]
[A]
1. Disassemble the fusing unit (see Fusing Unit Disassembly).
2. Remove the hot roller fusing lamp.
3. Remove the front [A] and rear [B] roller stoppers (1 screw each).
4. Remove the hot roller [C] and hot roller shaft bearings [D] (2 C-rings [E], 2
bushings [F], 2 gears [G]).
NOTE: Apply grease to the inner and outer surfaces of the bushings.
ø
CAUTION
Be sure to apply the grease to the bushings [F] after they have cooled. The
grease vaporizes when heated. The resulting gas is harmful if inhaled.
5. Clean the cleaning roller with a suitable solvent or replace the cleaning roller [I]
(2 E-rings).
[C]
[G]
[I]
A259R605.WMF
6-72
24 February, 1999
[D]
[E]
[G]
[F]
[B]
Advertisement
Table of Contents
