Power Supply (Pem) Leds; Switch Fabric Leds And Control Buttons; Line Card Leds And Control Buttons; Table 9: Power Supply Leds On The Craft Interface - Juniper EX9200 Manual

Power Supply (PEM) LEDs

Switch Fabric LEDs and Control Buttons

Line Card LEDs and Control Buttons

Copyright © 2016, Juniper Networks, Inc.
Each power supply has two LEDs on the craft interface that indicate its status. The
LEDs—labeled 0 through 3
Table 9 on page 23 describes the functions of the power supply LEDs on the craft interface.

Table 9: Power Supply LEDs on the Craft Interface

Label
OK
FAIL
Each Switch Fabric module has two LEDs on the craft interface that indicates its status.
The LEDs— and —are associated with control buttons and are located along the
OK FAIL
bottom of the craft interface. You can turn the SF modules on or off by pressing these
buttons on the craft interface.
Table 10 on page 23 describes the status of the SF module LEDs.

Table 10: Switch Fabric Module LEDs on the Craft Interface

Label
OK
FAIL
Each line card has two LEDs—
The line card LEDs are associated with control buttons and are located along the bottom
of the craft interface. You can turn a line card online or offline by using its control button
on the craft interface. Table 11 on page 24
Chapter 2: Updated Common EX9200 Topics
—are located on the craft interface next to the
Status Description
Green Power supply is functioning normally.
Off Power supply in not installed.
Red Power supply has failed.
Off Power supply is not installed or
functioning normally.
Status
Green
Unlit
Red
Unlit
OK and FAIL —on the craft interface that indicates its status.
describes the function of the line card LEDs.
PEM label.
Description
On steadily—The SF module is
functioning normally.
Blinking—The SF module is coming
online or going offline.
The SF module is not online.
The SF module has failed.
The SF module is not installed or is not
functioning normally.
23