Table of Contents
Advertisement
3
Attach the condenser.
(1)
Turn the coarse focus knob until the elevating
section is brought to the upper limit.
(2)
Turn the condenser focus knob until the condenser
holder reaches the bottom.
(3)
Insert the condenser, adjust it to face the front, then
secure it in place with the tool.
(4)
Turn the condenser focus knob until the condenser
holder reaches the top.
When using the motorized swing-out condenser,
secure the condenser cable using the three
protrusions (as shown), and then connect the cable
to the swing-out condenser connector on the main
body.
CAUTION
Make sure that the power to the microscope is turned
OFF before connecting the condenser cable.
Connect the motorized swing-out condenser cable
to the microscope main body so that a wider
protrusion among those at the end of the plug faces
the front (facing the observer).
Chapter 3
Assembly
Condenser focus knob
Swing-out
condenser
connector
Protrusions
69
POW ER
Condenser clamp screw
(use a tool)
Attaching the condenser
Motorized swing-out condenser cable
Motorized swing-out condenser
0.1
0.2
0.5
0.7
0.6
0.9
0.8
Protrusion
With a wider
protrusion on
Chap. 3
the front
Advertisement
Table of Contents
