Nikon Eclipse Ci-E Instruction Manual page 11

1 Power shutdown
To prevent electric shock and/or malfunction,
always turn off the power switch(es) for this
product and the peripheral devices (press to the
"O" position) and unplug the power cord from the
wall outlet before assembling this product,
connecting or disconnecting cables, or cleaning
this microscope and the objective.
2 Movement of motorized device
With this product, the motorized nosepiece can be
electronically rotated and the condenser top lens
can be electronically swung out. The various
motorized components can also be operated by
the remote controller or from a PC. Various
motorized components can also be operated from
remote controllers and PCs.
To avoid unexpected injuries, note the following in
operating motorized devices.
● Before operation, check the state of the entire
microscope system to ensure safety when
operating the motorized devices.
● Keep your hands and fingers away from the
nosepiece, objectives, stage, and components
and specimen on the stage to avoid injuries
during operation.
3 Prevent contact with water.
Never allow water to come into contact with this
product, and avoid using this product in
circumstances where it may be splashed with
water. Splashing water onto this product may
cause a short circuit, resulting in malfunction or
abnormal heating. If water is splashed onto this
product, immediately turn off the power switches
for this product and the peripheral devices (press
to the "O" position) and remove the power cord
from the receptacle. Then wipe off moisture with a
piece of dry cloth or something similar. If water
enters, stop the use of the product and contact
your nearest Nikon representative.
4 Do not place any object on top of the product.
Do not place any object on top of this product.
Safety Precautions
CAUTION
5 Cautions on assembling, installing, and
carrying the product
● Take care to avoid pinching your fingers or
hands during product assembly and
installation.
● Scratches or fouling optical components (such
as lens and filters) with fingerprints, etc. will
degrade microscope images. Be careful to
avoid scratches or direct contact with the lens
and filters when assembling.
● The main body weighs approximately 10 kg.
When moving it, hold the main body by the grip
on the back and the recessed portion at the
front bottom side of this product.
● Remove all attachments (if mounted) from the
microscope before moving the microscope.
● Do not place this product in a locker or cabinet.
6 Cautions on use, transportation, and storage
This product must be operated, transported, or
stored in accordance with the following conditions.
Installing this product in a hot, humid location may
result in the formation of mold or condensation on
lenses, impairing performance or causing
malfunctions.
● Operating conditions:
temperature: 0 to +40C, humidity: 60% RH
max. (no condensation)
● Transporting/storage conditions:
temperature: -20 to +60C, humidity: 90% RH
max. (no condensation)
7 Remove any covers from the product before
switching on.
Do not use this product while it is covered with a
piece of cloth, etc., as this will prevent heat
release and result in abnormal heat and create a
fire hazard. Do not cover this product with a piece
of cloth or similar while in use. The system
temperature will rise, resulting in a malfunction.
8 Cautions on sustained observations
To relieve fatigue resulting from long observation
sessions, limit continuous observations to one
hour. Take at least 10 to 15 minutes breaks
between observation sessions. Adjust the layout
of other equipment used and the height of your
chair.
9 Cautions on the disposal of the product
To avoid biohazard risks, dispose of this product
as contaminated equipment in accordance with
the standard procedure specified for your facility.
ix