Table of Contents
Advertisement
Home Monitoring & Control System
Discovering New Hardware
This section describes how to connect your system and only applies if you have already
successfully set up your MHM program.
Discover New Devices
For your MHM program to communicate with your wireless devices, they must be
registered. The MHM program establishes a dedicated wireless network with all discovered
Motorola home/office automation devices and works with only those devices that it has
discovered. Once the device is ready to be installed (it is powered and physically close to
the Gateway), the unit requires activation.
Use the following procedure to discover Motorola Home Monitoring and Control System
devices:
1
Log in to your MHM program, Start > Programs > Motorola Home Monitor >
Motorola Home Monitor.
2
From the main window, click
3
Click
4
Locate and press the Discovery buttons on your wireless devices. For your wireless
devices other than the PCM, use the Discovery tool.
The device LED will turn green when the Gateway has discovered it properly. Whereas
Camera LED's stay green; Sensor LED's are green for only a short time, since sensors
enter a sleep mode waiting for the next time to transmit. If the light does not turn green,
please consult the troubleshooting section of the device's user guide.
On the Discovery screen, you will see your devices appear as they are discovered.
5
Once all devices have been discovered, click
ready to work with your devices.
.
.
Discovery
Button
42
Discovery
Discovery
Button
Discovery Tool
. You are now
MHM User Guide
Advertisement
Table of Contents
