Table of Contents
Advertisement
Overview Installation Troubleshooting Contact
Connecting the VT2400/VT2500 to a Network
If you are setting up a wireless network only, the computers in the following diagrams will not use Ethernet cables
to connect them.
If you have an existing modem, follow the procedure in
you are setting up a network for the first time (adding devices to a single PC setup), see
Network" and then go to
Power connector
Setting Up a New Network
Follow these instructions if you have a single PC connected directly to the modem, or no Internet connection until
now.
1
Be sure the modem and the PCs are turned off and the
2
If you only have a single PC connected, disconnect the Ethernet cable from the PC to the modem (on the
modem end only) and connect it to a LAN port on the VT2400/VT2500.
3
Connect up to three additional PCs using Ethernet cables to the VT2400/VT2500. Connect one end of each
Ethernet cable to a PC and the other end to a LAN port on the VT2400/VT2500.
4
Connect one end of an Ethernet cable (RJ-45) to the modem, and connect the other end to the WAN port on
the VT2400/VT2500.
5
Connect up to two existing land phone lines (after you disconnect them from the wall jacks) and connect them
to the LINE 1 and LINE 2 ports on the VT2400/VT2500.
VT2400/VT2500 Series Voice Gateway User Guide
Configuration: Basic
"Configuring the Voice Gateway to the Modem"
LAN (Ethernet)
ports
FAQ Specifications Glossary License
Advanced
TCP/IP
"Adding the VT2500/VT2400 to an Existing
on page 17.
WAN port
Phone Line 1, 2
PSTN Failover
VT2400/VT2500
is unplugged.
Wireless
Network". If
"Setting Up a New
16
Advertisement
Table of Contents
