Motorola HMUG1080 User Manual page 77

Home Monitoring & Control System
What happens when don't know is selected as the channel in the Wi-Fi Info
section?
If you select don't know rather than a Wi-Fi channel, then the wireless cameras are free to
operate in any part of the Wi-Fi band and may disrupt a Wi-Fi network if one is in use.
I cannot uncheck the send to local archive check box.
There is currently an issue with this feature. When an action device is selected, it is grayed
out. When an action device is set to none, the checkbox can be unchecked but the entry
cannot be updated. The only way to stop a specific event from being sent to archives is to
remove the entry from event setup.
What do the USB Gateway LED states indicate?
Power LED
Off – USB Gateway is not powered up.
On (BLUE) – USB Gateway is powered up
Video LED
Off – no wireless cameras are turned on.
On (GREEN) – wireless camera is transmitting with a good signal.
On (YELLOW) – wireless camera is transmitting with a marginal signal.
On (RED) – wireless camera is transmitting with a poor signal.
Status LED
Off – MHM program not running.
On (GREEN) – all devices are OK.
On (YELLOW) – at least one device is reporting a yellow status.
On (RED) – least one device is reporting a red status.
Data LED
Off – MHM Program is not running or there is a radio frequency problem.
On (GREEN) – Radio is OK, blinks when talking to a wireless device.
What do the Wireless Camera LED states indicate?
LED OFF – the Wireless Camera is not powered up
LED RED – the Wireless Camera is powered up, but not discovered or the MHM
program is not running.
LED GREEN – the Wireless Camera is powered up, discovered, and the program is
running.
68
FAQ
MHM User Guide