Hitachi H8/500 Series Hardware Manual page 296

Steps 2 to 7 can now be repeated by setting the ADST bit to 1 again.
If the data transfer enable (DTE) bit is set to 1, the interrupt is served by the data transfer
controller (DTC). Steps 4 to 7 then change as follows.
4'. The DTC is started.
5'. The DTC automatically clears the ADF bit to 0.
6'. The DTC transfers the A/D conversion result from ADDRB to a specified destination address.
7'. The DTC ends.
282
Downloaded from Elcodis.com electronic components distributor