CYCLE PARTS
2
1
3
2
1
6
4
7
6
- 20 -
00
6.1.25 REMOVING THE FRAME
2
3
"
Remove engine, see see 3.1.2 (REMOVING THE ENGINE FROM THE
FRAME).
"
Remove horn, see 6.1.18 (REMOVING THE HORN).
"
Remove the steering unit, see 6.2 (STEERING SYSTEM).
"
Remove the rear swinging arm, see 6.3 (SWINGING ARM).
"
Remove the front subframe, see 6.1.23 (REMOVING THE FRONT
SUBFRAME).
"
Remove both footrest mounts, see 6.1.24 (REMOVING THE FOOTREST
MOUNT).
"
Disconnect number plate holder light connector (1).
"
Loosen and remove the four screws (2).
"
Remove the number plate holder (3).
"
Remove electrical parts from frame and release all cable clips.
6.2
STEERING SYSTEM
6.2.1
"
Remove the front shield, see 6.1.5 (REMOVING THE FRONT SHIELD).
"
Loosen and remove the two nuts (1). Save plate (2), cable ring (3), clamp
and bushing.
"
Take out the two split pins (4).
"
Loosen and remove the two nuts (5).
"
Remove the two arms (6) from steering yoke.
"
Remove split pin (7).
"
Loosen and remove nut (8).
"
Remove steering yoke with stem.
5
6
1
REMOVING STEERING YOKE WITH STEM
QUASAR 125-180
Release 00/2003 - 09