Omron NJ Series User Manual page 501

Connection status
General Additional
Status Status
(hex) (hex)
01 0205
01 0301
01 0302
01 0311
01 0312
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
Source of error
Error code returned from target:
There was a parameter error in the
frame used to open the connection.
Error code generated by originator or re-
turned from target:
Total number of tag sets that are set to
the product was exceeded.
Error code generated by originator or re-
turned from target:
The tag data link's allowable bandwidth
(pps) was exceeded.
Error code returned from target:
There was a parameter error in the
frame used to open the connection.
Error code returned from target:
There was a parameter error in the
frame used to open the connection.
16 Troubleshooting
Handling
Configuration Configuration
1 2
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Check the total Check the total
number of the number of the
tag sets that tag sets that
are set to the are set to the
product and set product and set
the tag sets so the tag sets so
that the total that the total
number does number does
not exceed the not exceed the
maximum of maximum of
the allowable the allowable
number. number.
Check the con- Check the tar-
nection set- get's connec-
tings (number tion settings
of connections (number of
and RPI) at the connections
originator and and RPI).
target. Check the con-
nection set-
tings (number
of connections
and RPI) at the
originator and
target.
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Configuration
3
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
Check the total
number of the
tag sets that
are set to the
product and set
the tag sets so
that the total
number does
not exceed the
maximum of
the allowable
number.
Check the con-
nection settings
(number of
connections
and RPI) at the
originator and
16
target.
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
16-15