Omron NJ Series User Manual page 327

Controller user event log
Parameter name
Index
Event occurred time
Event source
Event priority
Event code
Event priority details
Additional information[0]
to
Additional information[39]
Reserved[0]
to
Reserved[31]
NX Unit
Parameter name
Index
Unit number
Event priority
Event occurred time
Product code
Event code
Additional information[0]
to
Additional information[31]
 CIP Error Codes
General sta-
tus code
(hex)
02
0C
13
15
1F
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
Data type
UDINT
ULINT
UINT
UINT
UDINT
UINT
Array of BYTE
Array of BYTE
Data type
UDINT
USINT
USINT
UDINT
UDINT
UDINT
Array of BYTE
Error name
Resource unavailable
Object state conflict
Not enough data
Too much data
Vendor specific error
8 CIP Message Communications
Event log index number
This number is assigned when system event logs
and access event logs are registered.
Event occurred time
Event source
Event level
Event code
Event level details
Attached information (system information) of event.
Reserved
Event log index number
This number is assigned when system event logs
and access event logs are registered.
Unit number
0000 hex: Controller
0001 to 0020 hex: NX Unit
Event level
Event occurred time
Product code of the Unit in which event occurred
Event code
Attached information (system information) of event.
Cause
Resources needed for the object to perform the requested
service were unavailable.
The object cannot perform the requested service in its cur-
rent mode/state.
Data required for the execution of the required service is in-
sufficient.
Extra data for the execution of the required service is includ-
ed.
The service could not be executed due to internal reasons.
Description
Description
8-65
8