Procedure For Creating A Project In Ispsoft - Delta AS Series Operation Manual

A S S e r i e s O p e r a t i o n M a n u a l

6.2 Procedure for Creating a Project in ISPSoft

This section shows you the procedure for creating a project in ISPSoft. You can adjust the procedure according
to your needs.

Hardware configuration
You set the parameters such as a range of latched devices and a port number in a PLC. You configure the
modules with an AS300 Series CPU module, and set the parameters in these modules.

Network configuration
If a system uses a network architecture, or devices need to exchange data, use the network configuration
tool NWCONFIG in ISPSoft to configure a network and exchange data with COM as well as Ethernet.

Programming
After you write a program in ISPSoft, compile the program. If the compiling is unsuccessful, messages in
the Compile Message page show where the errors occur.

Testing and debugging
_6
Download the compiled program, the hardware configuration, and the network configuration to a PLC. You
can then test and debug the program online with the functions provided by ISPSoft.
Because the example introduced in this chapter does not discuss a network configuration, you only perform the
following procedure.
6 - 4