Cycle And Control Value Programming; General - Steris Reliance EPS Endoscope Processing System Operator's Manual

CYCLE AND CONTROL VALUE PROGRAMMING

IMPORTANT: A listing of the Safety Precautions to be observed when operating and servicing this
processor can be found in S
familiar with this information.

5.1 General

Cycle and Control Value Programming
1 of this manual. Do not operate the equipment until you have become
ECTION
The Reliance
following factory-set operating cycles:
• SINGLE endoscope processing cycle – For processing one
endoscope, placed in control handle boot "A", with or without a
WASHING phase.
• DOUBLE endoscope processing cycle – For processing two
endoscopes, placed in control handle boots "A" and "B", with or
without a WASHING phase.
• D-SHORT and D-LONG – Two decontamination cycles are
programmed for routine maintenance of the processor. Refer to
S 6, R
ECTION
Reliance EPS Processing Cycle is composed of a combination of
some, or all, of the following phases:
• WASHING – Includes WASH and RINSE segments.
This phase can be omitted by operator if only high level disinfection of
endoscope is required (refer to S
supervisor allowed this selection (see S
M
ISCELLANEOUS
repeated twice for each SINGLE or DOUBLE cycles (see S
5.2.3, S
ETTING
•
HIGH LEVEL DISINFECTION (HLD)
•
RINSE
•
AIR PURGE
See Table 5-1, Cycle Description Chart, for details on each cycle.
Operator Manual
™
EPS Processor is programmed with the
, for details.
M
OUTINE AINTENANCE
ECTION
). Supervisor can set WASHING phase to be
V
ALUES
M V
ISCELLANEOUS ALUES
4.8.2, S C
TARTING YCLE
5.2.3, S
ECTION
ECTION
).
920011-649
5
) and if
ETTING
5-1