Steris Reliance EPS Endoscope Processing System Operator's Manual page 115

5-14
920011-649
38. MULTIPLE PRINTOUTS feature is set to YES to allow operator
to generate more than one printout after each cycle.
Press SCROLL arrows (up or down) to enable (YES) or disable
(NO) MULTIPLE PRINTOUTS feature. Display shows:
After each cycle in progress, number of cycle printouts requested
is generated for each endoscope. If a DOUBLE endoscope
processing cycle is running, number of printouts doubles.
Press SCROLL arrows (left or right) to scroll to numbers and
set number of printouts to generate for each device. Up to two
printouts can be generated per device.
39. Press ENTER touch pad to confirm selection. Display shows:
40. EXTEND PRINTOUT feature is set to YES so additional space is
printed on cycle printout to allow operator to write down
additional information.
Press SCROLL arrows (up or down) to enable (YES) or disable
(NO) EXTEND PRINTOUT feature.
41. Press ENTER touch pad to confirm selection. Display shows:
42. PRINT VALUES screen allows supervisor to obtain a printout of
current Supervisor mode configuration settings. Press SCROLL
arrows (up or down) to choose (YES) or (NO).
43. Press ENTER touch pad to confirm selection. Display shows:
Operator Manual
CYCLE PRINTS PER
ENDOSCOPE X
EXTEND PRINT?
YES
__ blinking
PRINT VALUES
YES
__ blinking
PRINTING
Cycle and Control Value Programming