Setting Miscellaneous Values - Steris Reliance EPS Endoscope Processing System Operator's Manual

5.2.3 Setting Miscellaneous
MENU
Language
Time
Date
Bar Code Reader
IDs
0.2 µm Bacterial-
Retentive Filter
Countdown
WASHING Select
Option
Repeat WASHING
Water Sampling
Low Chemical
Warning
Automatic D-SHORT
Automated Leak Test
Enzyme Type
Printout Features
Print Values
Print Cycles
5-8
920011-649
Miscellaneous menu allows supervisor to set time and date, to
Values enable or disable printer functions or to print cycle values during
cycle. Miscellaneous menu includes the following settings:
FUNCTION
To set programmed language selection.
To set current time of day.
To set current date.
To activate or deactivate bar code reader (optional accessory).
To activate or deactivate scanning of Operator, Patient, Device, Procedure and
Physician IDs. Only with bar code reader present and activated.
To set number of days before filter alarm is triggered.
To allow operator to select WITH WASHING or WITHOUT WASHING.
To activate or deactivate REPEAT WASHING feature for SINGLE or DOUBLE
endoscope processing cycle.
To allow opening of chamber door just before draining sub-phase of RINSE 2 phase.
At that time, a sample of water can be taken from the sump.
To warn operator when chemical level is getting low (i.e. approximately five cycles to
process before chemical is empty).
To activate or deactivate second D-SHORT starting after 36 hours of inactivity.
If optional Automated Leak Test Assembly is present, to select automated leak test
feature so automated leak test can be performed at the start of an endoscope
processing cycle.
To select type of enzyme used with the processor.
To activate or deactivate duplicate, multiple and/or extended printout features to
generate more than one printout at the end of a processing cycle and/or to generate
additional space on printout to write down information.
To print current configuration programmed in Supervisor mode.
To print current cycle and phase values programmed.
1. Access Supervisor mode as explained in S
A
Operator Manual
S M
CCESSING UPERVISOR
SCROLL TO MODIFY
__ blinking
. Display shows:
ODE
SINGLE
Cycle and Control Value Programming
5.2.1,
ECTION