Steris Reliance EPS Endoscope Processing System Operator's Manual page 151

FAULT
Alarm sounds, and display shows:
FAULT 30
CYCLE DELAYED
alternating with:
SEE FAULT CHART
CYCLE DELAYED
Printout message:
HH:MM:SS XM
---------------------------------------
= FAULT 30
Alarm sounds, and display shows:
FAULT 31
CYCLE DELAYED
alternating with:
SEE FAULT CHART
CYCLE DELAYED
Printout message:
HH:MM:SS XM
---------------------------------------
= FAULT 31
Alarm sounds, and display shows:
FAULT 32
CYCLE DELAYED
alternating with:
SEE FAULT CHART
CYCLE DELAYED
Printout message:
HH:MM:SS XM
---------------------------------------
= FAULT 32
*Service charges may be incurred. Consult your warranty for details.
7-14
920011-649
1. Try to resume cycle by pressing START touch pad. If
2. 0.2 μm bacterial-retentive filter is defective. Replace filter
3. If situation reoccurs, confirm that venting connection is
MM-DD-YY
=
MM-DD-YY
=
1. An endoscope of a diameter larger than template is
2. Relief valve is not working properly. Call STERIS.*
3. Relief valve pressure incorrectly adjusted. Call STERIS.*
4. If 60 Hz processor, ensure there is a spacer between
MM-DD-YY
5. Try to resume cycle by pressing START touch pad. If
=
Operator Manual
POSSIBLE CAUSE AND CORRECTION
0.2 µm FILTER FAILURE
situation reoccurs, abort cycle.
cartridge. Refer to S
ECTION
attached to filter housing cap and filter housing cap is
properly installed (refer to S
reoccurs, call STERIS.*
AIR PURGE RTD HEATING MALFUNCTION
Try to resume cycle by pressing START touch pad. If
situation reoccurs, call STERIS.*
BOOT A: HIGH PRESSURE
Possible causes:
processed with insertion tube sleeve(s). Do not use
insertion tube sleeve for these endoscopes (refer to
S 4.3).
ECTION
valve cap and valve stem.
situation reoccurs, call STERIS.*
6.10.2 for procedure.
6.10.2). If situation
ECTION
Troubleshooting