Steris Reliance EPS Endoscope Processing System Operator's Manual page 110

Cycle and Control Value Programming
2. Press SCROLL arrows (up or down) until MISCELLANEOUS
appears.
3. Press ENTER touch pad to confirm selection. Display shows:
4. Press SCROLL arrows (up or down) to scroll through available
languages for display messages and printouts.
5. Press ENTER touch pad to confirm selection. Display shows:
NOTE: Time format can be changed from AM/PM to 24 h in
Service mode by a qualified service technician. For instructions,
refer to S 2, S
ECTION
Manual (P764333-736).
6. Press SCROLL arrows (left or right) to set current time of day.
7. Press ENTER touch pad to confirm time setting. Display shows:
NOTE: Date format can be changed to MM-DD-YY, DD-MM-YY
or YY-MM-DD in Service mode by a qualified service technician.
For instructions, refer to S
of Maintenance Manual (P764333-736).
8. Press SCROLL arrows (left or right) to set current date.
9. Press ENTER touch pad to confirm setting. Display shows:
BAR CODE READER
NOTE: Concerning bar code reader accessory, note the following:
1) Bar code reader function cannot be enabled if bar code
reader (accessory) is not installed.
2) If bar code reader is present, refer to Bar Code Reader
Installation Instruction (P920011-654), included with bar code
reader, or S
ECTION
Maintenance
programming instructions and bar code lists templates.
Operator Manual
LANGUAGE
ENGLISH
__ blinking
MISCELLANEOUS
TIME HH:MM
__ blinking
M P
ERVICE ODE ROCEDURE
MISCELLANEOUS
DATE MM-DD-YY
__ blinking
2, S
ECTION ERVICE
NO
__ blinking
2, S M
ERVICE ODE
Manual (P764333-736),
, of Maintenance
M P ,
ODE ROCEDURE
P , of
ROCEDURE
for complete
5-9
920011-649