Adding A Remote Unit Interface (Rui) Card - Simplex 4005 Programming Instructions Manual

Adding a Remote Unit Interface (RUI) Card

Adding a Remote Unit
Interface (RUI) Card
Technical Manuals Online! - http://www.tech-man.com
To add a Remote Unit Interface (RUI) Card, either a Status Command Unit
(SCU) or a Remote Control Unit (RCU) to the 4005, perform the following
steps:
1. Make sure all jumpers are set correctly and install the card. Refer to the
Field Wiring Diagram 841-990 for more information on wiring the RUI
cards.
After installing the RUI card, apply power to the 4005.
2. Follow Steps 1 through 3 under Editing a Point Label.
3. Press <Next> or <Previous> to scroll through the menus until
(GLW &DUG
[ ] is displayed (A) and then press <Enter>.
),5(  683(59,625<  7528%/( 
A.
3URJUDPPLQJ >(GLW &DUG@
),5(  683(59,625<  7528%/( 
B.
(GLW &DUG >$GG 58, &DUG@
&DUG >@
C.
&DUG 7\SH 6&8 &DUG
&DUG 
D.
&DUG 7\SH >6&8 &DUG@
Figure 2-18. Typical Screens Used to Add a
4. Press <Next> or <Previous> until [
then press <Enter>.
The focus brackets ( [ ] ) appear in the Card Address field (C) of the
display.
Note: Annunciator addresses are 1 through 16.
5. Press <Next> or <Previous> to choose the Card Address.
6. Press <ö> to move the focus brackets to the Card Type field of the
display (D).
7. Press <Enter> to confirm your selection.
"Configuring the card. . ." is displayed.
2-20
Remote Unit Interface Card
$GG 58, &DUG
] is displayed (B) and