Edit Mode Programming - Simplex 4005 Programming Instructions Manual

Edit Mode Programming

Edit Mode Programming
Technical Manuals Online! - http://www.tech-man.com
You can change the mode of a Generic Output point. (If another type of point is
chosen, you are notified that this is an invalid action.)
Mode editing of a point associated with the output of a SMPL equation is not
allowed.
Note: The following describes assigning Links between an LED of a
RCU card to a Fire monitor point (18-01).
To Edit the Mode of a point, use the following steps:
1. Follow Steps 1 through 5 under Editing a Point Label.
2. Press <Next> or <Previous> to scroll through the points until the point
you wish to edit is displayed (A) and then press <Function>.
3. Press <Next> or <Previous> to scroll through the menus until
(GLW 0RGH
[ ] is displayed (B) and then press <Enter>.
4. Press <Next> or <Previous> to scroll through the actions until the desired
action is displayed then use the <ö> to move the focus brackets ([ ]) to
the point you wish to link to a RCU/SCU point. Use <Next> or
<Previous> to scroll through the points until the desired point is displayed
(C) and then press <Enter> (see the Table 2-3 for your choices of Output
Modes and Link to... options).
5. A Confirmation screen appears (D) allowing you to make or abandon the
changes. Press <Enter> to confirm your choice, or <Exit/Clear> to
abandon your changes.
5&8 &DUG  /(' 
A.
/('
5&8 &DUG  /(' 
B.
&RQWURO >(GLW 0RGH@
0RGH 3URJUDPPLQJ ² *HQHULF 2XWSXW
C.
)LUH
3UHVV (17(5 WR &RQILUP (;,7 WR &DQFHO
D.
>)LUH@
Figure 2-12. Typical Screens Used in Edit Mode Programming
2-13

>@
 ²
Continued on next page