Simplex 4005 Programming Instructions Manual page 27

Operations Involving Cards:
Adding an Input/Output (I/O)
Adding an Input/Output (I/O)
Card
Technical Manuals Online! - http://www.tech-man.com
To add an Input/Output (I/O) card to the 4005, use the following steps:
Note: Refer to the SMPL Programming, Edit SMPL section of Chapter
6 for more information on card addressing and points.
1. Make sure all jumpers and relays are set correctly and install the card in
the Physical Slot desired (refer to Pub. No. FA4-21-700).
After installing the I/O card, apply power to the 4005. An "Extra I/O
Card" trouble occurs. Acknowledge the trouble and continue.
2. Follow Steps 1 through 3 under Editing a Point Label.
3. Press <Next> or <Previous> to scroll through the menus until
(GLW &DUG
[ ] is displayed (A) and then press <Enter>.
),5(  683(59,625<  7528%/( 
A.
3URJUDPPLQJ >(GLW &DUG@
),5(  683(59,625<  7528%/( 
B.
(GLW &DUG >$GG ,2 &DUG@
&DUG >@
C.
&DUG 7\SH 3RLQW 0RQLWRU
&DUG 
D.
&DUG 7\SH 3RLQW 0RQLWRU
Figure 2-13. Typical Screens Used to Add an Input/Output Card
4. Press <Next> or <Previous> until [
then press <Enter>.
The focus brackets ( [ ] ) appear in the Card Address field (C) of the
display. Refer to Table 2-3 for address information.
Card Addresses
27 27
Card Slot #10
26
26
Card Slot #9
25 25
Card Slot #8
24 24
Card Slot #7
23
23
Card Slot #6
Figure 2-14. I/O Card Address/Locations
2-15
3DQHO 6ORW 
3DQHO 6ORW 
$GG ,2 &DUG
18 18
19
19
20 20
21 21
22
22
Continued on next page
] is displayed (B) and
Card Slot #1
Card Slot #2
Card Slot #3
Card Slot #4
Card Slot #5