Editing Point Types - Simplex 4005 Programming Instructions Manual

Editing Point Types

Editing Point Types
Technical Manuals Online! - http://www.tech-man.com
To Edit the Point Type of a point, use the following steps:
1. Follow Steps 1 through 5 under Edit Label.
2. Press <Next> or <Previous> to scroll through the points until the point
you wish to edit is displayed (A) and then press <Function>.
A. ,2 &DUG  ,QSXW 
0RQLWRU =RQH
,2 &DUG  ,QSXW 
B.
&RQWURO >(GLW 3RLQW /DEHO@
,2 &DUG  ,QSXW 
C.
>),5( )LUH 0RQLWRU =RQH@
3UHVV (17(5 WR &RQILUP (;,7 WR FDQFHO
D.
>),5( )LUH 0RQLWRU =RQH@
Figure 2-11. Typical Screens Used to Edit Point Types
3. Press <Next> or <Previous> to scroll through the menus until
(GLW 3RLQW 7\SH
[
4. Press <Next> or <Previous> to scroll through the point types until the
desired type is displayed (C) and then press <Enter> (refer to the
Programming Sheets in Appendix A for a complete list of point types).
5. A Confirmation screen appears (D) allowing you to make or abandon the
changes. Press <Enter> to confirm your choice, or <Exit/Clear> to
abandon your changes.
The 4005 informs you when the Operation is Complete.
2-12

] is displayed (B) and then press <Enter>.