Enabling A Point - Simplex 4005 Programming Instructions Manual

Enabling a Point

Enabling a Point
Technical Manuals Online! - http://www.tech-man.com
To Enable a Point, use Figure 2-6 and the following steps:
1. View points by pressing <Menu> and <Next> until [
displayed, and then press <Enter>.
2. Press <Previous> or <Next> to display the Device Type of the point you
wish to enable and then press <Enter>.
The first point for that Device Type is displayed.
3. Press <Previous> or <Next> to display the point you wish to enable (A).
)LUVW )ORRU (DVW :LQJ
A.
0RQLWRU =RQH
)LUVW )ORRU (DVW :LQJ
B.
&RQWURO >(QDEOH@
)LUVW )ORRU (DVW :LQJ
C.
3UHVV (17(5 WR (QDEOH (;,7 WR FDQFHO
)LUVW )ORRU (DVW :LQJ
D.
3RLQW ZLOO (1$%/( LQ  (;,7 WR FDQFHO
Figure 2-6. Typical Screens Used to Enable a Point
4. Press <Enable/Disable>. Press <Previous> or <Next> until [
displayed (B).
5. Press <Enter> to enable the point.
6. Press <Enter> to confirm your choice (C).
The point enables in 30 seconds (D). Press <Exit/Clear> to stop the point
from enabling during this time period.
2-7
5RRP 
7528%/( 
5RRP 
6WDWXV ',6$%/('
5RRP 
5RRP 
9LHZ 3RLQWV
] is
(QDEOH
] is