Simplex 4005 Programming Instructions Manual page 101

Point Type Messages for Monitor Points,
Monitor Points (continued)
Technical Manuals Online! - http://www.tech-man.com
Pt. TYPE: SMOKE Description: Smoke Detector
Circuit Status LCD Readout (2
Normal Smoke Detector
Limited Smoke Detector
Open Smoke Detector
Short Smoke Detector
Disable TBL Smoke Detector
Class A TBL Smoke Detector
Used when only Smoke Detectors (both 2-wire and
Detailed Description:
4-wire) are connected to the circuit.
Figure 5-18. SMOKE Point Type
Pt. TYPE: EMERG Description: Combination Fire / Emergency
Circuit Status LCD Readout (2
Normal Monitor Zone
Limited Monitor Zone
Open Monitor Zone
Short Monitor Zone
Disable TBL Monitor Zone
Class A TBL Monitor Zone
Used to connect two types of alarm devices on the same
Detailed Description:
zone. For example, nurse call type devices and fire alarm devices. The
emergency alarm devices (nurse call) will require the use of a current limiting
resistor. Emergency devices cause a supervisory service condition.
Figure 5-19. EMERG Point Type
Pt. TYPE: GENMON Description: Generator Monitor
(No Supervisory)
Circuit Status LCD Readout (2
Normal Generator Monitor
Limited Generator Monitor
Open Generator Monitor
Short Generator Monitor
Disable TBL Generator Monitor
Class A TBL Generator Monitor
Used when Emergency generator monitoring is required.
Detailed Description:
The shorted condition of the circuit indicates an abnormal status and is
indicated by the Supervisory Service LED. The current limited condition of the
circuit will indicate generator is running in the alphanumeric display (if the
<ö> key is pressed) and can be tracked with an LED (must be programmed).
A current limiting resistor must be installed for this operation.
Figure 5-20. GENMON Point Type
5-7
Continued
nd
line)
nd
line)
SUPERVISORY
nd
line)
SUPERVISORY
LED
NORMAL
ALARM A
TROUBLE T
ALARM A
TROUBLE T
TROUBLE T
LED
NORMAL
S
TROUBLE T
ALARM A
TROUBLE T
TROUBLE T
LED
OFF
OFF
TROUBLE T
S
TROUBLE T
TROUBLE T
Continued on next page