Maintenance And Lubrication - JLG 600SC Service And Maintenance Manual

SECTION 1 - SPECIFICATIONS

1.8 MAINTENANCE AND LUBRICATION

NOTE: The following numbers correspond to those in Figure 1-1.
and Figure 1-2.
Table 1-15. Lubrication Specifications.
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of 350° F (177° C).
Excellent water resistance and adhesive qualities, and being of extreme
pressure type. 
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classification GL-5 or
MIL-Spec MIL-L-2105
HO Hydraulic Oil. Refer Section 1.6, Hydraulic Oil.
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104. Diesel - API
CC/CD class, MIL-L-2104B/MIL-L-2104C
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NOR-
MAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/
OR EXPOSED TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION
FREQUENCIES MUST BE INCREASED ACCORDINGLY.
1. Swing Bearing
Lube Point(s) - 1 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hrs of operation
Comments - Remote Access. Apply grease and rotate
in 90 degree intervals until bearing is completely
lubricated.
1-8
2. Swing Drive Hub
Lube Point(s) - Level/Fill Plug 
Capacity - 32 oz. (0.95 L)
Lube - 80w90 Gear Oil
Interval - Check level every 3 months or 150 hrs of
operation; change every 2 years or 1200 hours of
operation.
3. Drive Hub
FILL
ANTI - CLOCKWISE
DRAIN
Lube Point(s) - Level/Fill Plug
Capacity - 24 oz. (0.7 L)
Lube - 80w90 Gear Oil
Interval - Check level every 3 months or 150 hrs of
operation; change every 2 years or 1200 hours of
operation.
FILL PORT
CLOCKWISE
LEVEL
MAE25190
3121776