JLG 600SC Service And Maintenance Manual page 85

SPN
523352
523354
523470
523470
523470
523470
523470
523470
523470
523470
523550
523580
523580
523580
523601
523602
523602
523603
523605
523606
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
523612
3121776
Table 3-1. Deutz Trouble Codes (TD2.9 L4 Engine)
FMI
4 Injector cylinder-bank 2; short circuit
12 Injector power stage output defect
2 Pressure relief valve is forced to open, perform pressure increase.
2 Pressure Relief Valve (PRV) forced to open. Performed by pressure increase.
12 Pressure Relief Valve (PRV) forced to open. Shutoff conditions.
12 Pressure Relief Valve (PRV) forced to open. Warning conditions.
14 Open Pressure Relief Valve (PRV)
11 Pressure Relief Valve (PRV) error; Rail pressure out of tolerance range.
11 Rail pressure out of tolerance range.
The PRV can not be opened at this operating point with a pressure shock.
7 Maximum rail pressure exceeded (PRV).
12 Terminal 50 was operated too long
2 Data set variant with the desired number not found Invalid variant data set Identifier error No detail information
11 An error has occurred in the switch over to the desired data set variant in the code word.
Variant data set switching error No detail information
11 The code word could not be read correctly from the EEPROM Variant dataset switching error; No detail information
13 Failure of sensor supply voltage 3.
0 High fan speed; warning threshold exceeded
0 High fan speed; shut off threshold exceeded
9 Timeout Error of CAN-Receive-Frame AMB; Ambient Temperature Sensor
9 Timeout Error of CAN-Receive-Frame TSC1AE; Traction Control
9 Timeout Error of CAN-Receive-Frame TSC1AR; Retarder
12 Internal software error ECU; injection cut off
12 Internal ECU monitoring detection reported error
12 ECU reported internal software error
Internal ECU monitoring detection reported error
12 ECU reported internal software error
12 ECU reported internal software error.
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 Injection system, electrical error injectors
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 ECU reported internal software error
12 Diagnostic fault check to report the accelerator pedal position error
12 Diagnostic fault check to report the engine speed error
12 Error in the plausibility of the injection energizing time
12 Error in the plausibility of the start of energizing angles
12 Diagnostic fault check to report the error due to non plausibility in ZFC
SECTION 3 - CHASSIS & TURNTABLE
Error Identification
3-39