JLG 600SC Service And Maintenance Manual page 49

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
3121776
Track tension adjustment to be made between the idler and carrier roller: 0.781 in (19.8 mm)
Anti-Seize Compound to be used on master link pin before assembly. Torque Pad bolts over master link to 65 ft-lbs
+6,-6 then tighten 1/3 (120°)turn further.
Fill Plug
Check oil level of left & right crawler drives (0.69 Gal [2.6 L] grade 90 Gear Oil)
Drain Plug
Torque to 200 ft-lb, +15 -0 (280 Nm, +21 -0)
Use Gradall 8381-3109 Large Button Head Grease Fitting Adapter to Adjust Tracks
Torque to 65 ft-lb, +10 -0 (91 Nm, +15 -0)
Torque to 340 ft-lb, +25 -0 (476 Nm, +35 -0)
Offset in Idler Spring from center line of Idler to be oriented down.
Torque to 165 ft-lb, +15 -0 (231 Nm, +21 -0)
Apply Anti-Seize Compound to both mounting pilots Drive Motors
Torque to 230 ft-lb, +15 -0 (322 Nm, +21 -0)
Torque to 93 ft-lb, +10 -0 (130 Nm, +14 -0)
Torque to 53 ft-lb, +5 -0 (74 Nm, +7 -0)
Figure 3-3. Chassis Service Notes - 2 of 2
SECTION 3 - CHASSIS & TURNTABLE
3-3