JLG 600SC Service And Maintenance Manual page 145
Hide thumbs
Also See for 600SC:
- Operation and safety manual (120 pages) ,
- Operator's and safety manual (74 pages) ,
- Service and maintenance manual (270 pages)
Table of Contents
Advertisement
4. Pull moving end over track so new connection is posi-
tioned in curve of powertrack. Round half-shears will
rotate into cut-outs.
5. Parts shown below connect new link to powertrack.
3121776
SECTION 4 - BOOM & PLATFORM
6. Push pin through center hole. Slide washer on pin.
7. Install snap ring in groove on pin. Repeat pin installation
steps for all center holes with rivets removed.
4-29
Advertisement
Table of Contents
